Snapper Functions, Display Items, (Select Models), 12 Volt Power Outlet, Dashboard Display & Functions

Features & Controls

Dashboard Display & Functions	A					B
Display Items
Refer to Figure 3.							D
A. FUEL LEVEL
Indicates the amount of fuel in the fuel tank. Left is							C
empty; right is full.
B. HOUR METER / CLOCK / SERVICE INDICATOR					Cruise	PTO
Displays the clock, hour meter, and maintenance
reminder.	H			G		F	E
The hour meter measures the number of hours the key
	Figure 3. Dashboard Display - Select Models
has been in the RUN position. The hour meter will flash
an initial oil change indicator at 5 hours, and a lubrication	H. LOW VOLTAGE LIGHT
reminder every 50 hours. These reminders display for
	Indicates that the electrical system voltage is low. The
approximately two hours and will automatically reset
	light will turn on when the tractor is first started and then
themselves.
	go out. IF THIS LIGHT TURNS ON WHILE THE TRAC-
NOTE: The hour meter will register the passage of time	TOR IS IN USE, TURN THE ENGINE OFF IMMEDIATE-
when the key is in the RUN position, even if the engine is	LY. Contact your authorized dealer for service.
not running. The hour meter has a self contained power	Functions
source so the total hours are always visible.	DASHBOARD DISPLAY MODELS (SEE FIGURE 3)
C. SELECT BUTTON
	Display Total Running Hours - When the key switch is
Used to set the clock and reset the maintenance
	first turned		he RUN position, all warning indicators will
reminder.	light and he	o al running hours will be displayed. Be
D. SET BUTTON	sure all ligh s are functioning.
Used to set the clock and reset the maintenance	Display PTO Hours - Turn the key OFF, engage the
reminder.	PTO, and turn the key to RUN (engine off).
E. PTO LIGHT	Set the Clock - Start the engine, leave the engine run-
Indicates the PTO switch is in the ON position.	ning. Depress the select button (C) for three (3) seconds
	and release. Depress set button and HOLD to advance
F. CRUISE CONTROL LIGHT	time. Depress select button to select minutes. Depress
Indicates that the cruise control is engaged.	and HOLD set button (D) to advance time. Leave alone
	for 5 seconds and clock will activate. Shut off engine.
G. LOW OIL PRESSURE LIGHT
	Demonstration Mode - With the engine off, hold down
Indicates that the engine oil pressure is low. The light
	the set button (D) and turn the key switch to RUN.
will turn on when the tractor is first start and th go

out. IF THIS LIGHT TURNS ON WHILE THE TRACTOR	Maintenance Reminder - A maintenance reminder will
	display in the information window (B) after the first 5
IS IN USE, TURN THE ENGINE OFF IMMEDIATELY.
	hours of operation, and then after every 50 hours. The
Contact your authorized dealer for service.
	reminder will automatically reset after 5 hours. The
	reminder can be manually reset by turning the key switch
Reproduction
	from OFF to RUN (with engine off) and then depressing
	the set (D) and select (C) buttons simultaneously for 5
	seconds.

12 Volt Power Outlet(Select Models)

CAUTION

Avoid Injury. Safe operation requires your full attention. Do not wear radio or music headphones while operating machine.

The 12-volt accessory plug is located in the left side pod (D, Figure 1). It can be used to power small electronic devices. The accessory must be rated at 9 amps or less.

NOTE: Operating a 12-volt accessory, especially with the engine at idle, may cause battery discharge. When not using the accessory plug it must be covered with the rubber plug to prevent moisture from causing a short circuit. Entrance of water into plug can cause a short circuit.

13