Operating the Tractor
| Snowthrower | Snowthrower |
|
|
|
| & Dozer |
|
|
| |
| & Dozer |
|
| E | |
| Applications |
|
| ||
| Applications |
|
|
| |
|
|
|
|
| |
|
| A |
|
|
|
A |
|
|
|
|
|
B | F |
|
|
|
|
C |
|
|
|
| |
D | E |
| B | C | D |
| Mower | Mower |
|
|
|
| Applications | Applications |
|
| G |
|
| A |
|
|
|
the mower is reinstalled the downward Reproductionpressure lock |
| ||||
A |
| for |
|
|
|
B | F |
|
|
|
|
G | E |
| F | C | D |
| Not | Figure 18. Lift Link - Manual Lift Models | |||
Figure 17. Lift Lock Plate - Hydraulic Lift M dels | |||||
A. Lift Cylinder |
| A. Pin |
|
|
|
B. Flat Head Pin (Original) |
| B. Rear Hole of Lift Bar (Snowthrower Applications) | |||
C. Flat Head Pin (New) |
| C. Spacer |
|
|
|
D. Lock Plate |
| D. Hair Pin Clip |
|
|
|
E. Hair Pin Clips |
| E. Upper Hole (Snowthrower Applications) | |||
F. Lift Shaft Assembly |
| F. Slot of Lift Link (Mower Applications) | |||
G. Washers |
| G. Lower Hole (Mower Applications) |
|
When a
must be released so that the mower can float.
Fully lower the hydraulic lift. The lift assembly is spring loaded so it will need to be held in the down position to perform of the following procedures.
When using a snowthrower or dozer, the downward pressure lock plate (D, Figure 17) and an additional pin
(C)is installed. These parts are included with the attach- ment. Note that the washers (G) are not used with the lock plate.
When mowing, the downward pressure lock plate (D) is removed and replaced with two washers (G). The additional pin (C) is also removed.
NOTE: These instructions apply to Conquest / 1700 / 2700 / 400 Series tractors equipped with a lift lever kit.
The lift link is installed differently depending on what attachment is being used. Refer to Figure 18 for link installation information.
24