Section 3 - MAINTENANCE
3.1INTRODUCTION
To retain the quality of the mower, use genuine SNAP- PER replacement parts only. Contact a local SNAP- PER dealer for parts and service assistance. For the correct part or information for a particular mower, always mention model and serial number.
3.2SERVICE - AFTER FIRST 5 HOURS 3.2.1. CHANGE ENGINE OIL
! | WARNING | ! |
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Remove key. Disconnect spark plug wire and secure away from spark plug. Engine and compo- nents are HOT. Avoid serious burns, allow sufficient time for all components to cool.
NOTE: Due to the location of the oil drain plug under the engine, perform the following procedure for the easiest oil change:
1.Disconnect spark plug wire and secure end away from plug. The items needed to perform oil change are: cloth rags and a shallow pan.
2.Tip mower on its side, with the oil fill down. Do not tip mower with spark plug or carburetor down. See Figure 3.1.
TIP MOWER ON SIDE
OIL FILL
6.Fill engine with oil as specified in Engine Owner’s Manual. Thereafter, change oil after each 25 hours of use.
3.2.2. GREASE LEVEL IN TRANSMISSION
The transmission requires no lubrication or mainte- nance. If transmission leaks or malfunctions, return machine to an authorized Snapper dealer for repair.
3.2.3. WHEEL DRIVE CONTROL
The wheel drive control requires periodic adjustment to maintain proper drive function. The adjustment is performed with the thumbwheel located on the wheel drive control cable and requires no tools. Refer to Section “WHEEL DRIVE CONTROL ADJUSTMENT”.
FIGURE 3.1
3.Place shallow pan underneath the approximate center of the oil fill.
4.Remove oil fill cap and allow oil to drain out com- pletely in pan. Some oil may spill onto engine and hands, immediately wipe hands clean with cloth rags. Dispose of oil properly.
5.Tip mower back up.
10
