Section 2 - OPERATING INSTRUCTIONS
2.6 RECYCLING OPERATION
Converting this mower to the recycling operation requires no tools. First, STOP engine. Raise discharge door located at rear of machine. Remove grass catcher. Insert recycling plug fully into discharge opening. Allow discharge door to close. See Figure 2.7.
NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.
1.Set the cutting height at the highest cutting position.
2.Move engine speed control to “FAST” (Rabbit) posi- tion.
3.Move ground speed control to slowest speed set- ting.
4.Proceed mowing slowly. If grass is very dense, raise cutting height to improve recycling performance.
2.7INSTALLATION of GRASS CATCHER
1.Follow WARNING statement found on this page.
2.Lift discharge door located at the rear of machine. See Figure 2.8.
3.Install grass catcher onto the rear of machine. Position the rod ends of catcher frame over the tabs located at the rear of deck. Release discharge door, which is spring loaded, onto top of grass catcher.
LIFT DISCHARGE
DOOR
TABS
LIFT DISCHARGE
DOORCATCHER
HANDLE
GRASS
CATCHER
FIGURE 2.8
INSERT RECYCLING PLUG
FIGURE 2.7
! | WARNING | ! |
DO NOT operate mower without entire grass catcher, side chute or recycling plug in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.
! | WARNING | ! |
Grass Catcher bags used on SNAPPER products are made of woven fabric, and are subject to deterioration and wear during normal usage. Check condition of bag before each use. Immediately replace worn or damaged catcher bags with only bags recommended by SNAPPER. The grass catcher is optional equip- ment on some models.
9
