Snapper ERZT185440BVE manual Parking Brake Adjustment, Front Suspension Adjustment, Select Models

250 Z & Javelin Series

Parking Brake

Adjustment

1.Disengage the PTO, stop the engine, block the front wheels, remove the ignition key, and lock the motion control levers into their neutral lock positions.

2.Elevate the rear end of the unit, making sure it is safely supported.

3.Before attempting brake adjustment, check the brake gear (A, Figure 11), brake arm (B), park brake brack- et (D), brake rod (E), and compression spring (F) for dirt or debris that may affect brake operation.

4.Check to see that the brake arms (B) are engaged against the brake gears (A), with the teeth on the arms meshing with the teeth on the gears.

Note: The rear wheels may need to be moved slightly for the teeth to mesh properly.

5.With the parking brake engaged (motion control levers moved into their neutral locked positions), measure the length of the compression spring (F). The measurement should be between 2-1/2” and 2- 3/4”. If not, tighten or loosen the brake rod adjust- ment nut (C) until the correct measurement is achieved.

Front Suspension

Adjustment

(Select Models)

The shock assembly can be adjusted to vary the amount of pre-load applied to the springs. This allows the opera- tor to customize the ride according to operator’s weight and operating conditions.

LESS PRE-LOAD:

•Light operator weight

•Softer, more cushioned ride

•Best for relatively flat terrain

MORE PRE-LOAD:

•Heavy operator weight

•Stiffer, more rigid ride

•Better handling and greater stability on hilly terrain

TO ADJUST THE SPRING PRE-LOAD:

1.Park machine on a flat, level surface. Disengage the PTO, stop the engine and engage the parking brake.

D E

F

C

B

A

Figure 11. Parking Brake Adjustment

A.Brake Gear (One Each Side)

B.Brake Arm (One Each Side)

C.Brake Rod Adjustment Nut

D.Park Brake Bracket

E.Park Brake Rod

F.Compression Spring

INCREASE	DECREASE
	A

Figure 12. Front Suspension Adjustment A. Pre-Load Adjustment Collar

2.See Figure 12. Turn the pre-load adjustment collar

(A) CLOCKWISE to increase the pre-load, turn COUNTER-CLOCKWISE to decrease the pre-load. Make sure both shocks are set to the same amount of pre-load.

3.Secure the set collar by placing the rubber o-ring against it.

TP 300-5148-00-HZ-SN 14 1/2006