Section 2 - OPERATING INSTRUCTIONS
2.2.4.PARKING BRAKE
1.Engage parking brake by pulling the parking brake lever back to the “ON” position. See Figure 2.8.
2.Release parking brake by moving brake lever down to the “OFF” position. See Figure. 2.9.
JOYSTICK IN
NEUTRAL
POSITION
PARKING BRAKE LEVER IN ENGAGED “ON”
POSITION
2.2.5.CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any position, using deck lift switch. When in desired height of cut, release switch. See Figure 2.10. Observe the height of cut decal located on the upper right top side of the deck to place deck at the correct height of cut. See Figure 2.10. NOTE: The engine does not have to be running to adjust cutting height, but key switch must be in the “ON” position.
DECK HEIGHT OF
CUT DECAL
FIGURE 2.8
DECK LIFT
SWITCH
PARKING BRAKE DISENGAGED | FIGURE 2.10 |
“OFF” POSITION |
|
WARNING
DO NOT park the machine on slopes. DO NOT leave machine with engine running. Stop engine. Stop blades. Set brake. Remove key.
FIGURE 2.9
12
