Snapper EZF6100M, EZF2100DKU, EZF2300GKU, EZF5200M Introduction, Nomenclature

Section 1 – FAMILIARIZATION

CONTROL PANEL

MOTION CONTROL (JOYSTICK)

CONTROL PANEL (SEE INSET)

DECK HEIGHT OF CUT DECAL

DISCHARGE

DEFLECTOR

IGNITION	AMP	BLADE SWITCH
	METER
SWITCH

OPERATOR’S SEAT	LIGHT	DECK
HOUR		LIFT
	SWITCH	SWITCH
METER

FUEL TANK

PARKING BRAKE

ENGINE SPEED

CONTROL

DECK COVER

CASTER

WHEEL

BRACKET

FIGURE 1.1

1.1 INTRODUCTION

This manual has been prepared for the operator’s of the SNAPPER OUT FRONT Z-RIDER. Its purpose, aside from recommending standard operating procedures and routine service requirements, is to promote SAFETY through the use of accepted operating practices. Read, Understand and Follow the IMPORTANT SAFETY INSTRUCTIONS on Page 2 and 3 of this manual and All SAFETY messages on the OUT FRONT Z-RIDER and its attachments before operating. SNAPPER recommends returning the OUT FRONT Z-RIDER to an authorized SNAPPER dealer annually for inspection and addition of any new devices which might upgrade the safety of the mower.

1.2 NOMENCLATURE

The nomenclature information above, Figure 1.1, shows the essential parts of the SNAPPER OUT FRONT Z-RIDER. It is recommended that all operator’s of this equipment become thoroughly familiar with the controls, components, and operation of this machine before operating. Specific details involving the engine are found in the separate engine owner’s manual. Study these manuals before operating and keep both handy for future reference. For the nearest SNAPPER dealer in your area, check the yellow pages under the heading LAWN MOWERS. For engine parts and service, look for the engine manufacturer’s dealers under the heading, ENGINES - gasoline.

5