DRIVE ASSEMBLY
STEP 1:
1.Remove driven disc spring from driven disc assembly as shown. See Figure 9.
DRIVEN DISC
ASSEMBLY
DRIVE
DISC
DRIVEN
DISC
SPRING
TRANSFER
ROD
FIGURE 9
2.Manually adjust driven disc to position shown in Figure 10.
1/8” MEASUREMENT TO OUTSIDE EDGE OF DRIVE DISC
SLIDE DRIVEN DISC | DRIVE | |
ASSEMBLY TOWARD | ||
DISC | ||
OUTSIDE EDGE | ||
|
TRANSFER | OUTSIDE | |
ROD | ||
EDGE | ||
|
FIGURE 10
3.Slide Ground speed control lever fully forward. See Figure 11.
4.Install threaded end of Ground speed control rod, fitted with one
5.Thread rod in until upper end of rod aligns with hole in bottom of ground speed control lever. See Figure 11. Insert upper end of rod into hole, and secure with 5/16” flat washer and hair pin.
6.Slide Ground speed lever back, then fully forward again. Check driven disc position. If needed, repeat #5 above until 1/8” in Figure 10 is maintained, then tighten jam nut securely against ball joint.
7.Replace driven disc spring to driven disc assembly. See Figure 9.
GROUND SPEED CONTROL LEVER (FULLY FORWARD)
WASHER & HAIR PIN (HIDDEN)
GROUND SPEED
CONTROL ROD
FIGURE 11
(Operator Console and Ground speed handle
removed for clarity)
GROUND SPEED
CONTROL ROD
JAM NUT
BALL JOINT
PIVOT ARM
FIGURE 12
3