Snapper LT-200 Series manual Mower Deck Removal & Installation, Operating the Tractor

Mower Deck Removal & Installation

WARNING

Engage parking brake, disengage PTO, stop engine and remove key before attempting to install or remove the mower.

Removing the Mower Deck

1.Park tractor on a hard, level surface such as a concrete floor. Turn off PTO switch and engine, remove the key and apply parking brake.

2.Place wood blocks under the mower deck. Place the attachment lift in the lowest position.

CAUTION

Stored energy device. 44” & 50” mowers have spring lift assist. Lift lever must be in lowest cutting position and mower on support blocks to avoid injury when removing or installing mower mounting hardware. Return lift lever to highest position after hardware has been disconnected.

3.Move idler arm (A, Figure 5) to relieve belt tension. Remove belt from PTO pulley (B).

4.Remove hair pin (D, Figure 4) and washer (C). Disconnect the mower lift plates (A) from the tractor lift arms (B). Re-install washers (C) and hair pins (D) to prevent loss.

5.Return lift lever to highest position.

CAUTION

The muffler and surrounding areas may be hot.

6.Turn wheels straight ahead. Support the mower hanger (C). Remove safety clip (A, Figure 6) and rod

(B). Lower the mower hanger (C).

7.Turn wheels fully left, and slide mower deck out right side of tractor.

Installing the Mower Deck

1.Park tractor, shut off PTO and engine, remove the key and apply parking brake. Turn the wheels fully to the left.

2.Place the mower lift lever (A, Figures 7) in the lowest position. Slide mower deck under right side of tractor so that mower hitch is aligned with the front tractor hitch.

3.Turn wheels straight. Lift the mower hanger (C, Figure 6). Insert rod (B) through mower hanger (C) and tractor brackets (D). Secure with safety clip (A).

4.Re-install hair pins (D, Figure 4) and washers (C) into the mower lift plates (A) and the tractor lift arms (B).

Operating the Tractor

C

D

B

A

Figure 4. Lift Arms

(Viewed from underneath right side of tractor)

A.Mower Lift Plate

B.Tractor Lift Arm

C.Washer

D.Hair Pin

B A

Figure 5. Removing & Installing Belt

A.Idler Arm

B.PTO Pulley

B	D
D
	C
A

Figure 6. Mower Hitch

A.Safety Clip

B.Rod

C.Mower Hanger

D.Tractor Brackets

5.Move idler arm (A, Figure 5) to relieve belt tension. Install belt onto the PTO pulley (B).

15