Snapper NZM25523KWV 2, Stopping Machine, Safety Interlock System Checks, Engine Must not Start if

Section 3 - OPERATING INSTRUCTIONS

3,4,2, STOPPING MACHINE

1, Return motion controt lever to the neutral position & the neutral lock position.

IMPORTANT: Operator must use hand assistance to bring both motion control levers to the neutral position & the neutral lock position.

MOTION

CONTROL

LEVER

NEUTRAL

LOCK

POSITION

5.Raise and lock roll bar as soon as clearance permits. IMPORTANT: DO NOT use seat belt when roll bar is folded.

no roll-over protection when roll b

3.6SAFETY INTERLOCK SYSTEM CHECKS

This machine is equipped with an electrical safety interlock system that is provided for the safety of the operator and others. All safety devices must be in place and functioning properly before operating the machine. Perform the following interlock system checks periodically during the operating season. Contact your authorized Snapper dealer if you have questions.

FIGURE 3.13

2.Engage parking brake.

3.Push Blade Switch down to the "OFF" position to disengage or turn "OFF" the blades.

4.Stop engine. Move engine speed control to turtle "SLOW" position. Turn key to stop position.

5.Remove key.

DO NOT park the machine on slopes, DO NOT machine with engineWARNINGrunning, Stop engine.

blades, Engage parking brake, Remove key,

3.5FOLDING THE ROLL BAR PROTECTIVE STRUCTURE

The roll bar protective structure should be folded ONLY when absolutely necessary - i.e. when there is low overhead clearance. NEVER remove any part of the structure. To fold:

1.Shut off engine and remove key.

2.Loosen star knobs and remove locking pins. See Figure 3.14.

3.Fold roll bar down against backs of side bars.

4.Tighten star knobs and replace pins to prevent loss.

	LOOSEN
	STAR
	KNOBS &
FOLD	REMOVE
ROLL	LOCKING
BAR

FIGURE 3.14

WARNING

DO NOT operate machine if any safety interlock or safety device is not in place and functioning properly. DO NOT attempt to defeat, modify or remove any safety device.

ENGINE MUST NOT START IF:

1.Motion Control Lever(s) are not in the neutral lock position OR,

2.Parking Brake disengaged and Operator not seated in the Operator's Seat OR,

3.Blade Switch in the "ON" blades engaged

position.

ENGINE SHOULD START IF:

1.Blade Switch in the "OFF" blades disengaged position AND,

2.Motion Control Levers are both in the neutral lock position AND,

3.Operator properly seated in the Operator's Seat OR,

4.Parking Brake engaged.

NOTE: The engine can be started with the parking brake disengaged only if conditions in 1, 2 and 3 have been met.

ENGINE MUST BEGIN TO STOP IF:

1.Motion Control Levers are moved from the neutral lock position with Parking Brake engaged OR,

2.Operator rises off of seat with Blade Switch in "ON" blades engaged position OR,

3.Operator rises off of seat with Parking Brake disengaged.

IMPORTANT: Engine and blades will continue to run if Operator becomes reseated prior to engine coming to a complete stop. After coming to a complete stop, the blade switch must be moved to the "OFF" position before engine can be restarted. Engine and blades must come to a complete stop within 7 seconds after the operator rises off the seat or the blade switch is moved to the "OFF" position.

14