S150X 21HP, 23HP, 25HP & 27HP - 48” & 52” Mower Deck
Roll Bar Assembly
Install the Roll Bar
1.Unpack the roll bar and hardware from the box.
2.Remove the clevis pin (C, Figure 6) from the lanyard
(A).
3.Install the lanyard anchor (B) onto the lanyard as shown in Figure 6.
4.Reinstall the clevis pin on the lanyard.
A 
B
C
Figure 6. Assemble the Retainer Pins
A.Lanyard
B.Lanyard Anchor
C.Clevis Pin
Assemble the Top Loop
1.Install the plastic cap (B, Figure 7) into the end of the top loop tube (A). Repeat for other end of tube.
2.Install the rubber stop (C) against the inside of the pivot mount. Repeat for other end of tube. See Figure 7.
Install the Upright Tubes
1.Remove the bolts and nuts on one side of the machine that secure the rear bumper for shipping. Save this hardware for reinstallation in Step 3.
2.Place the roll bar upright tube onto the outside of the rear bumper (A, Figure 8). Refer to Figure 9 for the correct roll bar orientation.
3.Refer to the insert in Figure 8. Loosely install a bolt with a flat washer through the both holes of the upright tube, rear bumper, and the frame from the outside of the machine. Loosely install a nylock flange nut on the bolt.
4.Repeat process for the other side of the machine.
B
A
C
Figure 7. Assemble the Top Loop
A.Top Loop Tube
B.Plastic Cap
C.Rubber Stop
A |
| F |
B | C | A |
| E | |
| D |
Figure 8. Upright Tube Placement (Left Side Shown)
A.Upright Tube
B.
C.1/2” SAE Washer
D.Rear Bumper
E.Frame of the Machine
F.
10/2007 | 5 | TP |
