Snapper S150X manual Adding Fuel, Starting The Engine

S150X 21HP, 23HP, 25HP & 27HP - 48” & 52” Mower Deck

Adding Fuel

To add fuel:

1.Remove the fuel cap (see A, Figure 26).

2.Fill the tank to about 1-1/2” (3,81 cm) of the bottom of the filler neck. This will allow for fuel expansion.

NOTE: Do not overfill. Refer to your engine manual for specific fuel recommendations.

3. Install and hand tighten the fuel cap.

Starting The Engine

1.While sitting in the operator’s seat, engage the parking brake and make sure the PTO switch is disengaged and the motion control handles are locked in the NEUTRAL position.

2.Set the engine throttle control to FULL throttle position. Then fully close the choke by pulling the knob OUT fully.

3.Insert the key into the ignition switch and turn it to

START.

4.After the engine starts, gradually open the choke (push knob down fully). Reduce to half throttle speed and allow to warm up.

Warm up the engine by running it for at least a minute before engaging the PTO switch or driving the rider.

5.After warming the engine, ALWAYS operate the unit at FULL THROTTLE when mowing.

A

Figure 26. Adding Fuel

A. Fuel Cap

10/2007 13 TP 300-7343-A-M1-SP