Snapper Snow Thowers manual Dealer Pre-Sale Checklist, Lubrication, Operational Test

DEALER PRE-SALE CHECKLIST

The following must be accomplished upon the sale of the snow thrower. It is very important that the Dealer performs and accomplishes the set-up and the operational tests as listed below. Check (✓) items actually performed and signed on this page.

LUBRICATION

_____ ENGINE OIL added to bring level up to full mark on 4-cycle engines (Refer to Engine Manual).

_____ GEAR CASE grease level checked, add Benalene 900 grease (Snapper Part No. 2-9577) if needed.

OPERATIONAL TEST

_____ AUGER DRIVE CONTROL checked for proper engagement and disengagement to insure auger stops within 5

seconds after auger clutch control is released.

_____ WHEEL DRIVE CONTROL checked for proper engagement and disengagement of wheel drive.

_____ ENGINE started, engine speed control settings checked and adjusted as needed.

_____ IGNITION SWITCH checked to insure engine stops when turned to OFF position.

_____ ENGINE ELECTRIC STARTER checked for proper operation.

_____ FUEL SYSTEM checked for leaks around tank and connections.

______DISCHARGE CHUTE CRANK checked for proper operation and free rotation.

______AUGER and WHEEL DRIVE CONTROL CABLES checked and adjusted per instructions in the Operator’s Manual.

_____ GROUND SPEED CONTROL checked and adjusted per instructions in the Operator’s Manual.

_____ CHOKE CONTROL checked for proper operation during start up.

_____ TIRE PRESSURE checked. 15 to 20 PSI if chains are to be installed or 12 PSI if chains are not being used.

_____ AUGER DRIVE CONTROL stops auger when released.

_____ WHEEL DRIVE CONTROL stops wheel drive when released.

_____ CHECK LIGHT checked for proper operation.

DEMONSTRATION & INSTRUCTION

_____ PERSONALLY HANDED Operator’s Manual & Snow Thrower Safety Booklet to purchaser.

_____ INSTRUCTED purchaser to read and follow instructions in Operator’s Manual.

_____ DEMONSTRATED proper starting procedure and operation of snow thrower to purchaser.

_____ INSTRUCTED purchaser how to service air cleaner, maintain oil level (4-cycle).

_____ ASSISTED purchaser in completing Product Registration Card.

DEALER’S RECORDS & CONSUMER/OPERATOR PRODUCT REGISTRATION CARD

Purchase Date __________________ Model_______________________ Serial No. _______________________

Retailers Name ___________________________________		Signature ____________________________________
Address _____________________________________	City ____________________ State _______		Zip ______
MACHINE WILL BE USED COMMERCIALLY? _____ YES _____ NO
Purchaser’s Name ________________________________		Signature ____________________________________
Address ____________________________________	City _____________________ State _______		Zip _______

IMPORTANT: This form is to be retained by the Dealer for future reference regarding Warranty, proof of purchase, traceability for product recall or service, etc. Complete the Product Registration Card and Mail to Customer Service Department at SNAPPER, P.O. Box 1379, McDonough, Georgia, 30253.

INSTRUCTION No. 7-4367 (I.R. 05/9/01) Printed in U.S.A.

4