Snapper SPV21675, SPV21675E, NSPV21675, NSPV21675E Rear Cover Removal and Installation

! WARNING !

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

Rear Cover Removal and Installation

To Remove the Rear Cover

1.Remove the three fasteners (A, Figure 24) securing the rear apron to the machine.

2.Remove the two fasteners (B) securing the rear cover to the machine.

3.Slide the cover (C) down and out to remove. Set all components aside.

To Install the Rear Cover

1.Reverse steps 1-3 above, making sure the tab (D) on the rear cover is located on the outside of the machine.

D
C
B	Maintenance
	A
Figure 24: Removing the rear cover

15