! | WARNING | ! |
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.
| A |
Operation | B |
|
Figure 9: Deflector locking tab
Removing the Recycling Plug
1.Raise the rear discharge door (A, Figure 10).
2.Remove the recycling plug (B) from the rear discharge chute.
Note: The recycling plug should be removed only when bagging is desired, and should be replaced as soon as bagging operations are completed.
B
A
Figure 10: Removing the recycling plug
Installing the Grass Bag
1.Raise the rear discharge door (A, Figure 11).
2.Remove the recycling plug. Refer to the section entitled “Removing the Recycling Plug”.
3.Holding the grass bag handle (B), install the grass bag onto the back of the mower, making sure that the grass bag hooks (A, Figure 12) are hooked onto the rear door pivot rod (B).
B |
A |
Figure 11: Installing the grass bag
A |
B |
Figure 12: Grass bag hooks
! | WARNING | ! |
Grass Catcher bags used on SNAPPER products are made of woven fabric, and are subject to deterioration and wear during normal usage. Check condition of bag before each use. Immediately replace worn or damaged catcher bags with only bags recommended by SNAPPER. The grass catcher is optional equipment on some models.
8 | www.snapper.com |
