Installation and Initial Setup
■Unpacking
Carefully unpack the QV171-HDSDI monitor and verify that the following items are included:
•QV171-HDSDI Monitor
•V-PS12-5V-1 Power Supply with 2-Pin Twist Lock Connector
•Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage, immediately contact Marshall Electronics at (800) 800-6608. If you are not located within the continental United States, call +1 (310) 333-0606.
■Installation
The QV171-HDSDI can be mounted in any standard EIA 19” equipment rack. The attached rack ears can be angled to provide the user control over the viewing angle. Adequate ventilation is required when installed to prevent possible damage to the monitor’s internal components.
A VESA standard 75mm hole pattern also allows custom mounting installations. Alternately, the QV171-HDSDI can be used in a desktop configuration with optional stand (Marshall part number V-ST15).
QV171-HDSDI with optional desktop stand (Marshall Part Number V-ST15)
■Connections, Power-On and Initial Setup
Plug the V-PS12-5V-1 power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the 2-pin twist lock connector to the back of the monitor. Connect the required cables for video signals input and output. (Power must be applied to the QV171-HDSDI for the active loop-though output to be activated.) The monitor defaults to ‘ON’ when power is supplied.
For IMD setup details, see IMD Configuration Submenu on page 21.
