STEP 3: Insert the Card Make sure you have soft reset your device after software
installation before you insert the card.
Insert the card into your Pocket PC’s SDIO slot. Make sure the card is
positioned correctly. Do not insert the card upside-down or force the card in
too hard.
IMPORTANT! To remove the SDSC 3E, push the card
completely into the slot. After the card springs back, you can
safely remove the card. Do not pull the card out without
pushing first, or you can damage the connector the next time
you insert a card.
Do not soft reset the Pocket PC when the Socket card is
inserted, or errors may occur in applications using the card.
If errors occur, remove the card and soft reset the device.
Wait for the device reset to finish before you re-insert the
card.
The SDIO slots of some Pocket PCs will continue to draw
power from the Pocket PC’s main battery whenever an
SD/SDIO card is inserted (whether the card is from Socket or
another manufacturer), even when the Pocket PC is turned
off (suspended). If you have one of these Pocket PCs, Socket
recommends that you completely remove the card whenever
the card is not in use. For more information, please visit:
www.socketcom.com/support/support_bar.asp
CHAPTER 2: SETUP FOR POCKET PC 2003 11