5
ENGLISH
Installation instructions for 7755 plus
Insert the screws into the holes in the display holder (a) and hand-tighten
them using the enclosed, self-locking lock nuts (b). Run the measuring
cable up the rear side of the display stand (d). Insert the display holder (a)
with the locking nuts (b) into the guide groove (c) of the display stand and
fasten it. Push the display unit down into the display holder (a) until it
locks into place.
Getting started
Insert batteries (4 x 1.5 V AA) or connect the unit to a power supply.
Position the scale at its place of use. Make sure it is horizontal.
The scale is ready for operation.
If you want to fix the display unit to a wall, attach the enclosed display holder
(a) to the wall and push the display unit down into it until it locks into place.
Plug-in power supply unit
The socket (f) for connecting the supplied plug-in power supply unit is
located at the base of the display unit (e). Insert the cable and run it into
the cable grip. Always use an original Soehnle Professional power supply
unit. The power supply unit is not waterproof and therefore must not come
into contact with water.
Should the power supply unit become wet or show visible signs of damage,
do not operate the scale with the power supply unit. Please contact your
dealer or service partner.
Power supply
You can also operate the scale using Soehnle Professional rechargeable
batteries besides the plug-in power supply unit and zinc/carbon or alkali/
manganese batteries (4 x 1.5 V AA).
Please note that the batteries are not charged when the power supply unit
is switched on. You require a separate battery recharging unit.
Recharging kit (optional)
You can obtain Soehnle Professional rechargeable batteries as part of a
separate kit, consisting of a recharging unit, Soehnle Professional recharge-
able batteries and a safety sticker. When inserted, Soehnle Professional
rechargeable batteries have sufficient charge for up to 200 hours of weighing
(depending on the recharging level of the batteries). During recharging
(approx. 15 hrs), an indicator lamp is lit on the recharging unit. Start a new
loading cycle by removing and then inserting the flat plug on the display
unit. If you do not use the rechargeable batteries for a long time, they will
lose some of their capacity. The batteries are fully charged after approx. 3
to 5 recharging cycles.
Replacement parts: Soehnle Professional rechargeable batteries, recharging unit
When you insert rechargeable batteries into the unit, attach the supplied
sticker to the battery compartment.
1. The sticker reads as follows: Caution! Rechargeable Soehnle Professional
batteries in use, do not replace with other batteries.
Caution: if you use normal batteries with the battery recharging unit,
there is a danger of leakage and explosion. If you start using normal
batteries again, replace the battery recharging unit with the plug-in
power supply unit supplied with the scale.
2. The power supply unit is a battery recharging unit and can be recognised
by the LED on the housing.
Dispose of used (rechargea-
ble) batteries in accor-dance
with the national and local
regulations for environmental
protection and recycling.
a
e
Technical data
Refer to the information on the display unit
for weight range and numeric intervals.
The power supply data is given on the plug-in
power supply unit.
Working temperature: 5 – 35°C
Storage temperature: -10 – 55°C
f
b
c
a
d