Mounting Hardware
| Qty. |
3/4"screws | 6 |
lock frame | 2 |
sash lock | 1 |
TOOLS NEEDED:
Phillips Screw Driver
Drill (If pilot holes are needed)
CAUTION
When handling unit, be careful to avoid cuts from sharp metal edges and aluminum fins on front and rear coils.
How to Install
NOTE: Top Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained!
Place unit on floor, a bench or a table. There is a
1Left and Right Window Filler Panel - be sure to use the proper panel for each side.When installed
the flange for securing the panel in place to the window sill will be facing into the room.
A. Hold the |
|
Accordion | FIG. 2 |
Panel in one | |
hand and |
|
gently pull |
|
back the |
|
center to free |
|
the open end. |
|
See Figure 2. |
|
FIG. 3A
B.Slide the free end (“I”section) of the panel into the cabinet as shown in Figures 3A, 3B & 4. Slide the panel down. Be sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.
FIG. 3B
FIG. 4
C. Once the panel |
|
has been | FIG. 5 |
installed on the | |
side of the |
|
cabinet, make |
|
sure it sits |
|
securely inside |
|
the frame |
|
channel by |
|
making slight |
|
adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. Figure 5.
D.Slide the panel all the way in and repeat on the other side.
7
