Soleus Air HI1-50-03 manual Operation, Adjusting The Air Flow Direction

OPERATION

NOTE: The first time you operate this heater, it may emit a slight odor and some smoke. This is due to the residual cleaning agents used to clean the element during manufacturing. This is normal op- eration and will cease after the heater has been used for a few minutes.

ADJUSTING THE AIR FLOW DIRECTION

1.Rotating the unit - if the unit has been installed with a single lag bolt, simply rotate the entire unit as needed to adjust the direction of the air flow.

2.Tilting the unit - Loosen the bracket screws, tilt the heater to the desired position, and re-tighten the bracket screws. NOTE: To tilt the heater it must be mounted in bottom keyhole slots of mounting brackets to maintain adequate clearance and prevent possible overheating.

3.Adjust the louvers to the desired position. NOTE: The louvers are designed so they cannot be completely closed. Do not attempt to close the louvers completely as this may damage the unit.

.

To prevent possible electric shock, disconnect the power to the heater at the main service box be- fore attempting to adjust the heat output of the unit.

10