OPERATING PROCEDURES & MAINTENANCE
Unpacking your Wine Cooler
1)Remove the exterior and interior packaging.
2)Make sure that all the parts listed below are included with your wine cooler.
5 removable wine racks
1 flat type half shelf
1 (staggered) lower shelf
3)It is advisable to clean the inside of the Wine Cooler with lukewarm water using a mild detergent and a soft cloth, and then to dry it thoroughly prior to use.
4)Find a location for your unit that is protected from direct sunlight and other sources of heat. Place the unit on a level surface. Make sure that there is at least 5 inches of space between the back of your unit and the wall. Avoid locating the appliance in moist areas. Too much moisture in the air will cause condensation to form, requiring more frequent defrosting of the unit.
5)Allow one hour for the refrigerant fluid to settle before plugging it in.
6)The refrigeration system of the cabinet is designed to operate with the cabinet located on a flat surface. Avoid tilting the cabinet side.
Connecting Your Wine Cooler
Improper use of the grounded plug can result in the risk of electrical shock.
This unit should be properly grounded for your safety. The power cord is equipped with a
Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician.
This appliance requires a standard 115/120volt, 60Hz electrical outlet with
6