Soleus Air SG-WAC-08ESE-C, SG-WAC-06ESE-C manual If AC is Blocked by a Storm Window

ASSEMBLY & INSTALLATION (CONT.)

4.To secure the lower sash into place, use the sash lock and a 4/5 ” screw as shown below (See FIG. 9)

FIG. 9

IF AC is Blocked by a Storm Window

A storm window frame will not allow the air conditioner to tilt properly which in turn will keep it from draining properly. To adjust for this, attach a board or piece of wood to the sill. The board or wood piece should have a depth of at least 1 1/2”. Make sure the board or piece of wood is ap- proximately 1/2” higher than the storm window frame. This will allow the air conditioner to tilt enough for proper drain- age. (See FIG. 12).

SASH

FIG. 12

5.For added insulation, cut the supplied insulation foam to the width of the window. Insert the foam between the window sashes to prevent air and objects from getting into the room. (See FIG. 10)

FIG. 10

STORM	1 1/2” MIN	Board or wood
WINDOW		piece must be
	(38 mm)
FRAME		approximately
		1/2” higher
		than the storm
		window frame
		for proper
		drainage

Removing the Air Conditioner from the Window

1.Turn the air conditioner off, and disconnect the power cord.

2.Remove the sash seal from between windows, and unscrew sash lock.

3.Remove the screws installed through the frame and frame lock.

4.Close (slide) the side panels into frame.

5.Keeping a firm grip on air conditioner, raise the sash and carefully “rock” air conditioner backward to drain any condensate water in base of unit. Be careful not to spill any remaining water while lifting unit from window.

6.Store parts with the air conditioner in the box

9