S O N A F I L L ™ I N S TA L L AT I O N I N S T R U C T I O N S
A C O U S T I C D A M P I N G M A T E R I A L
SONAFILL INSTALLATION INSTRUCTIONS
The Sonafill™ system is composed of four 6” x 12” damping tiles and two square acoustic pillows. The four tiles are adhered to the inside surface of the wall above and below the speaker cutout; the pillows are placed in the wall cavity above and below the speaker cutout. The Sonafill system greatly reduces the coloration caused by drywall reso- nance. Another benefit of the Sonafill system is the reduction in sound transmitted to the room located behind the speaker.
Step 1
Sonafill installation begins with the drywall installed and finished and the speaker mounting hole already cut. Any fiberglass already in the stud bay where your Sonafill will be installed should be pushed away from the speaker cutout approximately 15” up and down. This allows enough space for installation of Sonafill and its proper operation.
Step 2
Locate the four Sonafill
Step 3
Locate the two acoustic pillows. Install one pillow inside the wall 2” above the speaker cutout. Install the second pillow 2” below the speak- er cutout. The pillows contain a
Step 4
Install the speakers in the wall as usual. You will notice a dramatic increase in the clarity and definition of bass and mid bass frequencies. The reduction of drywall resonance will be most noticeable on male voice, drums, bass guitar, as well as any type of surround sound effect containing low to mid frequencies.
Front View
Acoustic Pillow
Damping Tiles
Damping Tiles
Acoustic Pillow
Side View
Sonance • 212 Avenida Fabricante • San Clemente, CA
©2000 Sonance. Sonafill is a trademark of Sonance.