Sharp LC-60LE822ERU operation manual Initial auto installation, Digital broadcast setting

Quick guide

Initial auto installation

When the TV is powered on for the first time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.

Confirm the following before turning on the power

EIs the antenna cable connected? E Is the AC cord plugged in?

E Is the MAIN POWER switch turned on (;)?

1Press <Aon the TV.

• The initial auto installation wizard appears.

2Setting the OSD language.

Press a/b/c/dto select the desired language, and then press ;.

3Selecting the location of the TV.

HOME STORE

Press c/dto select where you will use this TV, and then press ;.

•The confirmation screen pops up only when selecting “STORE”. Press c/dto select “Yes” or “No”.

•HOME: “STANDARD” will be the default value for the “AV mode” setting.

•STORE: “DYNAMIC (Fixed)” will be the default value for the “AV mode” setting. If the “AV mode” is changed, the TV will automatically switch back to “DYNAMIC (Fixed)” when there is no signal input from the TV or remote control unit for 30 minutes.

•STORE: A demonstration image will be displayed after initial auto installation is completed. If you have chosen “STORE” by mistake, go to “Setup” > “View setting” > “Reset” > select “HOME” again.

4Setting the country.

Press a/b/c/dto select your country or area, and then press ;.

•This setting screen only appears during the first installation.

NOTE

•If you set “Sweden” in the country setting, you can select the cable provider “ComHem”. Refer to the Hmark in the following steps or instructions about the settings for “ComHem”.

5Starting channel search.

Digital search

Analogue search

Skip

Press a/bto select “Digital search”, “Analogue search” or “Skip”, and then press ;.

•To watch both analogue broadcasts, digital broadcasts and satellite broadcasts, you should perform the auto installation setting for each format (Page 32).

•If you want to search for more broadcasts, execute “Additional search” from the “Programme setup” menu (Pages 32_34).

•When you select “Skip”, only “Satellite search” will be performed. You should perform “Digital search” and “Analogue search” from “Auto installation” under the “Setup” menu if needed.

•After performing “Digital search” or “Analogue search”, the screen swithes to the “Satellite search” setting. You should then execute “Yes” if you want to search for the satellite channels.

NOTE

•If you turn off the power on the TV while performing a channel search, the initial auto installation wizard will not appear. The auto installation function allows you to execute the installation again from “Setup” > “View setting” (Page 32).

•The initial auto installation wizard will abort if you leave the TV unattended for 30 minutes before searching for channels.

•After initial auto installation is completed, the default PIN is automatically set to “1234”. To change the PIN setting, refer to Password/Lock settings (Page 35). To clear the PIN setting (PIN input will no longer be needed), refer to CLEARING THE PIN (Page 52).

•When “Italy” is selected in the country setting, the default age restriction value is set to 18.

Digital broadcast setting

Press c/dto select “Terrestrial” or “Cable”, and then press ;.

Terrestrial Cable

H

•When you set “Sweden” in the country setting and select “Cable” for the searching format, you can select the cable provider “ComHem”.

ESearching for terrestrial broadcasts

The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.

• To abort the initial auto installation in progress, press 6.

After searching for DVB-T channels, the screen switches to the “Satellite search” setting (Page 13).

11