8

Removing the stand unit

To mount the TV on the wall, the stand unit has to be removed. Please refer to the following to remove the stand.
Before performing work, remove the cables and four caps on the rear of the TV unit.
WARNING
Removing the stand unit and mounting the LCD colour TV require special skills and should only be performed by qualified
service personnel. Customers should not attempt to do the work by themselves. SHARP bears no responsibility for
accidents or injury caused by improper removing or mounting.
CAUTION
The TV unit is very heavy, be careful not to drop it on the floor or your feet.
Be sure to perform the work by at least two personnel.

Remove the stand cover.

Unfasten and remove the three short screws
from the three holes on the stand cover.
Remove the stand cover from the two latches
on the stand base.
2
1

Unfasten and remove four short screws from

the four holes on the rear of the TV.

1
1
2
2

Lift the TV unit to remove it from the stand.

NOTE
To attach the stand unit, perform the steps in reverse order.
A screwdriver is not supplied with this product.
The stand base is made of glass. Therefore, be careful not to
drop the stand base or apply pressure to it.
Do not place heavy objects on the stand base.
3
•
•
•
•
CAUTION
The stand is made of tempered glass. Read the following precautionary instructions carefully and use it properly.
Do not drop or place unnecessary stress on the stand when assembling and attaching or removing it.•
Be sure to not accidentally hit the glass part of the stand with a sharp or hard object, as it may cause the glass to break.•
Using tempered glass with scratches for extended periods may lead to damage occurring. If there are scratches on the tempered
glass, do not attempt to use the stand.
•
•
•
•
•

Preparation