Sharp LC-60LE822ERU operation manual Checking signal strength and channel strength DVB-T/C/S/S2

Quick guide

Checking signal strength and channel strength (DVB-T/C/S/S2)

If you install a DVB-T/C/S/S2 antenna for the first time or relocate it, you should adjust the alignment of the antenna to receive a good reception while checking the antenna setup screen.

1Go to “Menu” > “Setup” > “View setting” > “Channel settings” > “Antenna setup- DIGITAL”.

2Press a/bto select “Digital setup” or “Satellite setup”, and then press ;.

Channel strength of DVB-T

Supply voltage	Frequency	MHz
Signal strength
Channel strength	CH No.
	Signal strength

Current Max.

Quality

Current Max.

Channel strength of DVB-C

EChecking signal strength

3Press a/bto select “Signal strength”, and then press ;.

Signal strength for DVB-T/C

Supply voltage

Signal strength

Channel strength

Frequency	MHz
Symbol rate
QAM modulation
Signal strength

Supply voltage

Signal strength

Channel strength

CH No. Signal strength

Current	Max.
Quality
Current	Max.

	Current	Max.
Quality
	Current	Max.

Channel strength of DVB-S/S2

Signal strength	Frequency	MHz
Channel strength
	Symbol rate

Signal strength for DVB-S/S2

Signal strength

Channel strength

Signal strength
Current	Max.
Quality
Current	Max.

EChecking channel strength

4Press a/bto select “Channel strength”, and then press ;.

•You can input a specified frequency band using the 0_9 numeric buttons.

Supplying power to the antenna

Band		Vert/Low
Signal strength
	Current		Max.
Quality
	Current		Max.

5Position and align the antenna so that the maximum possible values for “Signal strength” and “Quality” are obtained.

NOTE

•The values of “Signal strength” and “Quality” indicate when to check the appropriate alignment of the antenna.

You must supply power to the antenna in order to receive digitally/terrestrially broadcast stations or satellite broadcast stations after connecting the antenna cable to the antenna terminal on the rear of the TV.

1� Press @and the “Menu” screen displays.

2� Press c/dto select “Setup”, and then press ;.

3� Press c/dto select “View setting”, and then press ;.

4� Press a/bto select “Channel settings”, and then press ;.

5� Press a/bto select “Antenna setup-DIGITAL”, and then press ;.

6� Press a/bto select “Supply voltage”, and then press ;.

7� Press c/dto select “On”, and then press ;.

15