INSTALLATION INSTRUCTIONS
CB2Z
TWO ZONE CONNECTING BLOCK
The Model CB2Z is a device that provides routing of infrared remote control signals. Independent control of two audio/video systems can be obtained from two zones. One emitter port is provided for each zone, plus one common port so that certain components can be controlled from both zones. The CB2Z is a simplified unit, intended for use when only two zones are needed.
SPECIFICATIONS
• Inputs: 2 - Four screw removable connectors to interface with all
• Outputs:Two zone emitter ports and 1 common emitter port (3.5mm miniature phone jacks).
• Can be used with a CB1 Connecting Block or an ACB1 Amplified Connecting Block for COMMON emitter expansion. (See Fig. 4 & 5)
• Uses Sonance E1,VE1,E2 and VE2 Mini Emitters.
• Power requirements: 12 volts DC. Uses PS1 or PS2 Power Supplies.
• 2.1 mm coaxial power jack.
• Dimensions:
Fig. 1: CB2Z Two Zone Connecting Block
Mounted in 3” SNAPTRACK®
(SNAPTRACK is a registered trademark of AUGAT)
Fig. 2: 470 Ohm Capacitance
Discharge Resistor
CAUTION: For Shielded Wire and Long Lead Lengths
When using lengths greater than 200 feet of
Pg