![](/images/new-backgrounds/1000991/99115x1.webp)
3.Set the iPort’s Volume Control YES/NO switch to the left (NO) position (no volume control in system).
•The iPort’s volume control circuit will affect all zones in a
4.Plug the audio Cat5 cable’s
5.Install the iPort Audio Wallplate in an electrical box in the room where the audio equipment is located.
Important: Do not install an iPort Wallplate in the same electrical box as AC house wiring, a light switch or any other
6.Plug the included 15V DC power supply into the Power connector on the Wallplate.
7.Use a stereo RCA audio cable to connect the Wallplate to a source input on the audio system.
8.If the audio system has a compatible IR control output, use a mono 3.5mm mini cable to connect it to the Wallplate’s IR connector.
9.If the audio system has a compatible
Pin 1: | PC RX | Pin 4: | PC TX |
Pin 2: | GND* | Pin 5: | PC RX |
Pin 3: | GND* | Pin 6: | Unused |
* Only one GND pin connection is required.
Note: For complete information about
10.In installations where the Audio Wallplate is located more than 250 feet from the iPort: Run a length of 16/2 speaker wire through the wall, from the Wallplate’s Aux Power
Figure 5:
IW-3, IW-4 & IW-5
Auxiliary Power
Connection
iPor t ver. IW | 8 | Instruction Manual |