Sonance MR1 installation instructions Features, Specifications, Installation, Micro Ir Receiver

MR1insMan.qxd 12/20/02 5:16 PM Page 1

INSTALLATION INSTRUCTIONS

MR1

MICRO IR RECEIVER

The MR1 IR receiver has been designed for mounting in very small spaces. It may be mounted under shelf edges, cabinet ledges, etc. – anywhere an inconspicuous appearance is desired. The high sensitivity of these receivers allows reception of IR commands up to 25 feet away.

FEATURES

•Very small package.

•Works in a standard 3-wire system.

•System talk-back LED.

•Includes 3-Terminal Block for easy extension of 18" ribbon cable.

•12 units may be powered by one PS1 power supply.

•Has a 7 Foot, three-conductor ribbon cable with stripped and tinned ends.

•Circuitry contained in a shielded chassis.

SPECIFICATIONS

•Infrared carrier frequency bandwidth: 30 - 100 kHz.

•Reception range: up to 25 feet.

•Nominal reception angle: + 55 degrees off axis.

•Cable requirements: 3-conductor, 24 to 18 gauge (unshielded OK).

•Maximum transmission length: One mile using 18 gauge wire.

•Maximum current output: 100 mA.

•Maximum number of directly driven IR Emitters: 4 (8 if 4 E2 emitters are used).

•Dimensions: 7/16" x 5/16" x 2-1/8" (11.2mm x 8.5mm x 55mm).

•Power requirements: 12 volts DC @ 10 mA.

INSTALLATION

MR1. These units are intended to be wired to the input terminals of Sonance Connecting Blocks or other devices, using the supplied 3-terminal block in the remote room location. A 3- conductor cable (24 gauge up to 200', 22 gauge up to 600', 20 gauge up to 2000', 18 gauge up to 5000') is run to the main room. Connections are then made to a Sonance connecting block, power supply, and emitters as shown in the following illustration of a typical basic system:

7/16"	MR1
	IR Receiver
	Talkback LED
	2-1/8"
Red (or white)
Stripe	OUT
	+12V
7 Foot Ribbon Cable	GND

3-Terminal Block (supplied)

IR Photodiode

Hand Held

Remote

3-Conductor Inter-room Cable (unshielded OK)

PS1

Power Supply

120 V AC (Unswitched)

CB1

Connecting Block

PWR	EMITTERS CB1 ONEZONE CONNECTINGBLOCK
IR RCVR
+12VDC
GND
STATUS
SIGNAL

Satellite Receiver

E1 Emitter

DVD

E1 Emitter

AV Receiver

E1 Emitter

REMOTE ROOM

MAIN ROOM

Pg 1