SONANCE SYMPHONY® SST, SSTR and SRS1

4.The speaker’s connector posts are spring- loaded. Push the top of each connector post down to open the connector and insert the exposed wires into the holes in the posts. SST and SSTR models have two sets of connectors, one for the left amplifier channel and one for the right.

•The speaker’s positive post is labeled with a red dot; the negative post is labeled with a black dot. Double-check that you connected amplifier “+” to speaker “+” and amplifier “–” to speaker “–”.

5.Make sure all the RotoLock clamps are in the full clockwise position so that they are tucked within the mounting hole’s border. Insert the

speaker into the hole in the ceiling (Figure 6). The RotoLock system can accommodate a maximum ceiling material thickness of 1¼”.

•The FastMount tabs will prevent the speaker from falling out of the mounting hole, allow- ing the installer to let go of the speaker to pick-up tools or other items.

NOTE: THE FAST MOUNT TABS ARE

DESIGNED FOR ONE-TIME USE ONLY. IF

THE SPEAKER IS REMOVED FROM THE

MOUNTING HOLE THE FASTMOUNT TABS

WILL DISCONNECT AND REMAIN INSIDE THE

CEILING .

FastMount® Tabs

RotoLock® Clamps

F

R

F i g u r e 6 : I n s e r t S p e a k e r

F i g u r e 7 :

I n t o M o u n t i n g H o l e

T i g h t e n R o t o L o c k C l a m p s

6. Tighten the four screws on the front of the

speaker baffle. The RotoLock clamps will automatically rotate into position and begin clamping the speaker (Figure 7).

• When you notice resistance on the screws the speaker has been clamped successfully.

NOTE: THE SPEAKER

FLANGE IS

DESIGNED

TO FLEX AND CONFORM TO ANY SMALL IMPERFECTIONS IN THE CEILING SURFACE. DO NOT TIGHT-

EN THE SCREWS SO

MUCH SO

THAT THE

FLANGE BOWS-OUT.

Important: Always use low-torque settings; NEVER over-tighten.

7.Attach the grille after the speaker has been installed. Insert about half of the grille into the groove at the edge of the speaker. Gently fit the remaining half of the grille by working around the speaker, fitting the grille into the groove as you go.

NOTE: YOU CAN ADJUST THE TORQUE APPLIED TO THE ROTOLOCK SCREWS TO ACHIEVE A PROPER GRILLE FIT.

8