SonicWALL 170 manual Click Next

2.Change Password - Change the administrative password. This is the password for the admin account.

Old Password	Should be populated with the default password, password.
New Password	Enter your new password.
Confirm	Re-enter your new password.

Note: Keep your new password in a safe place. If you lose your password, you will have to reset the SonicWALL security appliance to factory settings and lose your configuration. For instructions on resetting your SonicWALL security appliance, refer to the SonicOS Standard Administrator’s Guide.

Click Next.

3. Change Time Zone - Change the Time Zone setting to your local time zone.

Time Zone	Select the time zone for your location from the list.
Automatically	Check this setting if you live in an area that observes Daylight
adjust clock for	Saving Time.
daylight saving time

Note: It is important that you set the time zone correctly before you register your SonicWALL TZ 170 Wireless.

Click Next.

4.WAN Network Mode - The Setup Wizard automatically detects most networking modes. If it does not detect a networking mode, you may have a static IP address. See Procedure 1, “Collecting Internet Service Provider (ISP) Information” on page 5.

Confirm the selection or select the correct type of network connection for your network.

Static IP	Select Static IP if you want to give the SonicWALL TZ 170 Wire-
	less a specific, unchanging IP address.
DHCP	Select DHCP if your ISP assigns your computer a dynamic IP
	address. DHCP is commonly used with cable modems.
PPPoE	Select PPPoE if your ISP requires a username and password to
	establish a connection and assign a dynamic address. PPPoE is
	commonly used with DSL modems.

Page 12