SonicWALLSSL-VPN 2000 Getting Started Guide Page 21

Scenario A: Configuring a DMZ or OPT Port in SonicOS Standard

1. Navigate to the Network > Settings page.
2. Click the Configure button for the DMZ or OPT interface.
3. Select the DMZ in NAT Mode radio button.
4. Enter 192.168.200.2 in the DMZ Private Address field.
5. Enter 255.255.255.0 in the DMZ Subnet Mask field.
6. Click the OK button.

Scenario A: Allowing WAN -> DMZ Connection in SonicOS Standard

Follow this procedure if you are connecting the SonicWALLSSL-VPN 2000 to a
SonicWALL UTM appliance running SonicOS Standard. If your SonicWALL UTM
appliance is running SonicOS Enhanced, skip to “Scenario A: Allowing WAN -> SSL-
VPN Connection in SonicOS Enhanced” on page 28
9Tip: Leave the default rule to deny any access from WAN to DMZ in place, and use the
Public Server Rule Wizard to create an access rule to allow HTTP and HTTPS
specifically to the SonicWALL SSL-VPN appliance. As you add different servers to the
DMZ, you can use the wizard to create access to the new servers while still restricting all
other traffic.
Note: If you are allowing HTTP access to your SonicWALL SSL-VPN appliance as well
as HTTPS access, you need to run the wizard twice to create public server access rules
for both HTTP and HTTPS.
Create a public server access rule for HTTPS traffic:
1. Navigate to the Firewall > Access Rules page.
2. Click .
3. In the Welcome to the SonicWALL Network Access Rules Wizard page,
click Next.