Page 4
Applying Power to the SonicWALL SSL-VPN 2000
1. Plug the power cord into the SonicWALL SSL-VPN 2000 and into an appropriate
power outlet.
2. Turn on the power switch on the rear of the appliance next to the power cord.
The Power LED on the front panel lights up green when you turn on the
SonicWALL SSL-VPN 2000. The Test LED lights up yellow and may blink for up
to a minute while the appliance performs a series of diagnostic tests. When the Test
light is no longer lit, the SonicWALLSSL-VPN 2000 is ready for configuration.
If the Test or Alarm LEDs remain lit or if the Test LED blinks red after the
SonicWALL SSL-VPN 2000 has booted, restart the SonicWALLSSL-VPN 2000. For
more troubleshooting information, refer to the SonicWALL SSL-VPN Administrator’s
Guide.
Continue to Step
X0:
Default management port.
Provides connectivity between
the SSL-VPN and your gateway.
Console Port: Provides access
to command line interface.
(for future use)
Power LED
Test LED
Alarm LED
X2:
10/100 Ethernet
X1:
10/100 Ethernet
X3:
10/100 Ethernet
Power plug Power switch
Exhaust fans