Enclosure Setup
A – Assemble Rail Assemblies & Install Them Into Rack
1.Adjusting for the depth of the rack you will install the Fusion storage system, secure an extension bracket to a main rail using two each of the supplied screws, lock washers, flat washers, and nuts (Figure 3); do not overtighten the nuts. Secure the other extension bracket to the other main rail.
Support Notes: The Fusion rail assemblies are mounted inside the rack rails, not hooked around them.
There are four mounting holes in the main rail. Use its top and bottom holes to secure the main rail to the rack. The two middle holes are used to secure the Fusion storage system to the rack and rails.
2.Using two of the supplied screws, secure the main rail section of a rail assembly to the front of the rack (Figure 4); do not overtighten the screws.
Support Note: There are three mounting holes in the extension bracket. Depending on the rack’s hole pattern, two
holes should always be available for securing the extension bracket.
3.Using two of the supplied screws, secure the extension bracket section of a rail assembly to the back of the rack (Figure 5); do not overtighten the screws.
4.Repeat steps 2 and 3 for the remaining rail assembly.
WARNING: The Fusion RX1600RAID enclosure is heavy without drives installed; do not install the drive modules until after you
install the enclosure into the rack.
B - Mount the Drive Enclosure Into Rack
1.Holding it level with the rail assemblies, slide the RX1600RAID enclosure into the rack (Figure 6).
right rail assembly
left rail assembly 
Figure 3
main rail
section
screw
screw 
extension
bracket
Figure 4
screw
extension
bracket
screw
Figure 5
Figure 6
4