50US
7Press .
[Auto Calibration] starts.
The system adjusts the speaker settings
automatically.
Be quiet during the measurement.
Note
•Before [Auto Calib ration], make sure that the
surround amplifier turns on and you install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
•When you use the W ireless Surround Speaker
Kit (WAHT-SBP2, optional) for the surround
back speakers (page16), install the speakers in
appropriate location and turn the surround
amplifier on. To use the surround back speakers,
set [Surround Back] in [Speaker Settings] to
[Yes] (page50)
8Confirm the conclusions of [Auto
Calibration].
The speakers connected to the unit are listed
as [Yes] on the TV screen.
Note
•If measurement fails, follow the message then
retry [Auto Calibration].
•The measurement for [Subwoofer] is always
[Yes] and [Speaker Settings] returns to the
default setting when you perform [Auto
Calibration].
9Press X/x to select [OK] or [Cancel],
then press .
xThe measurement is OK.
Disconnect the calibration mic, then select
[OK]. The result is implemented.
xThe measurement is not OK.
Follow the message, then select [OK] to
retry.
Note
•While the Auto Calibration func tion works:
– do not turn off the power.
– do not press any button.
– do not change the vo lume.
– do not change the func tion.
– do not change the di sc.
– do not insert a disc.
– do not disconnect the calibration mic.
Setting the Speakers

[Speaker Settings]

To obtain the best possible surround sound, set
connection of the speakers and their distance
from your listening position. Then use the test
tone to adjust the level and the balance of the
speakers to the same level.
1Press HOME.
The home menu appears on the TV screen.
2Press C/c to select [Setup].
3Press X/x to select [Audio Settings],
then press .
4Press X/x to select [Speaker Settings],
then press .
The [Speaker Settings] display appears.
5Press X/x to select the item, then press
.
Check the following settings.
x[Connection]
If you do not connect center or surround
speakers, set the parameters for [Center] and
[Surround]. Since the front speaker and
subwoofer settings are fixed, you cannot change
them.
When you use the Wireless Surround Speaker
Kit (WAHT-SBP2, optional) for the surround
back speakers (page 16), set [Surround Back]
also.
[Front]
[Yes]
[Center]
[Yes]: Normally select this.
[None]: Select this if no center speaker is used.
[Surround]
[Yes]: Normally select this.
[None]: Select this if no surround sp eaker is
used.
[Surround Back]
[Yes]: Select this if surround back speakers are
used.
[None]: Select this if no surround back speakers
is used.