Preparations for Using the Networking Function

You can connect this device to the network with the LAN cable (10BASE-T/ 100BASE-TX).

This section describes the tasks that are required for using the networking function of this device.

Installing this device

Before installation

•Before installation, make sure that the power to all the equipment is off. To turn the display completely off, press the 1 switch so that the display changes to standby mode, then disconnect the power cable from the wall outlet.

•When you install this device, make sure that the flat panel display is locked and stable.

Follow the steps below to install this device to the FWD-50PX1/50PX1N Flat Panel Display.

1 Remove the already installed option adaptor (for FWD-50PX1) or the panel cover (for FWD-50PX1N).

FWD-50PX1:Loosen the two screws located on the top and bottom of the option adaptor. Use a slot screwdriver to turn the screws counterclockwise, and then remove the option adaptor carefully.

When the option slot is located on the right side*

OUT IN

S CONTROL

1

REMOTE

 

 

R

 

AUDIO

L

 

IN

 

 

VIDEO

OUT

 

VIDEO INPUT

IN

2

ADAPTOR

OUT

 

S

 

 

VIDEO

IN

 

*The location of the option slot differs depending on the model of the Display Unit. Refer to the Instruction Manual of the FWD series as well.

GB6 Preparations for Using the Networking Function