FWD-50PX1N:Loosen the two screws located on the top and bottom of the panel cover. Use a Philips screwdriver to turn the screws counterclockwise, and then remove the panel cover.

When the option slot is located on the right side*

OUT IN

S CONTROL

1

REMOTE

 

2

1

*The location of the option slot differs depending on the model of the Display Unit. Refer to the Instruction Manual of the FWD series as well.

2 Check the direction (top/bottom) of this device and insert it into the flat panel display. Make sure that the connector inside the display is firmly connected.

Using a slot screwdriver, tighten the two screws of this device. Connect the LAN cable, as needed.

OUT IN

S CONTROL

2

REMOTE

 

NETWORK

 

MANAGEMENT

1

Caution

Do not touch the connectors in the Display. Doing so may result in injury to yourself or cause this device to malfunction.

Preparations for Using the Networking Function 7GB