Sony BRCSDP16 instruction manual Electrical Specifications, Preparing Pendant Mount Model

ELECTRICAL SPECIFICATIONS

Heater and Blower Only

!Power 24 VAC, Class 2 Only

For BRCSDP16

53 watts at 24 VAC (heater and blower)

30 watts at 24 VAC (camera) Input Connectors:

BNC

(2)screw-down connectors RJ-45 Connector

PREPARING PENDANT MOUNT MODEL

GENERAL INSTRUCTIONS:

Tools Required: .100" Flat Head Screwdriver

Phillips Head Screwdriver

Slotted Head Screwdriver

1Carefully remove the housing from the packaging material. Check to be sure all parts are present.

2This unit includes a 1½" NPT housing coupling that can be used with a standard 1½"" NPT pipe. The housing can be used with other brackets designed with 1½"" male pipe threads, such as the UNI-WMA1 wall mount bracket.

3Attach the housing coupling to the bracket or pendant pipe (Figure 1).

NOTE: Pipe threads should be clean and rust free. Use a sealer (such as Teflon™ tape or silicone sealer) on the threads.

Add thread

sealing tape

Figure 1

Be sure the bracket is properly and securely mounted ! to a supporting structure capable of rigidly holding the

weight of the entire unit.

INSTALLING QUICK RELEASE BRACKET AND PAN/TILT CAMERA ASSEMBLY (ALL MODELS)

1Using the security tool provided, open the housing by loosening the (3) captive security screws located on the housing ring next to the lower clear dome (Figure 2).

Loosen three

Figure 2security screws holding dome

2Install the pan/tilt unit quick-release bracket. It is recommended that this be done before installing the housing. On the next page are instructions for mounting the camera into the housing.

3It is recommended that the camera be installed at this time. Connect to the quick-release bracket as shown and secure per manufacturer directions.

4Clean the inside of the dome, with the text-wipe provided. Reattach the housing dome and secure the (3) captive screws. Do not overtighten the screws. Tighten only to the point at which the gap between the ring and the housing top closes.

INSTALLING THE HOUSING ASSEMBLY

1Mount the housing assembly to the mounting bracket and housing coupling. A safety cable is included with the housing to temporarily hold it while making wiring connections. Loop the safety cable over one of the set screws on the housing coupling and make the appropriate connections using the (2) screw-down connectors supplied.

2Undo the safety cable and twist the housing onto the housing coupling. Secure all (3) setscrews provided on the housing coupling (Figure 3).

3Clean the outside of the dome.

Twist and

Secure

Figure 3