1Battery attachment section

Attaches a BP-L60/L60A/L90/L90A Battery Pack, a DC-L1 Battery Adaptor containing an NP-1B/1A Battery Pack, or a DC-L90 Battery Adaptor containing a BP-90A/90 Battery Pack.

For details on battery attachment, refer to the operation manual of the camcorder.

2RET (return video) button

Pressing this button allows you to use the viewfinder on the camcorder as a monitor for portable VTR. In input mode, this button can be used as a substitute for the RET button on the lens.

3VTR START button

In input mode, this button controls record and pause operations on the camcorder.

4EARPHONE jack

Connects an earphone for monitoring of the sound signal recorded by a portable VTR.

5VTR connector (26-pin)

Inputs and outputs video signals, audio signals, or control signals from the CAMERA connector on a portable VTR.

Power is not supplied from the portable VTR through this connector to either the CA-702/702P itself or the camcorder.

6DC IN (DC power input) connector (XLR type, 4-pin, male)

Connects an AC adaptor or an external battery through a DC output cable. Power input to the CA-702/702P is supplied to the camcorder. When the CA-702/702P is connected to a camcorder, the DC IN connector on the back of the camcorder cannot be used. The DC IN connector can thus be used in place of the one on the camcorder. In this case, the power supply to the camcorder remains continuous even when power to the CA-702/702P is turned off.

7DC OUT (DC power output) connector (4-pin) Supplies power to an optional WRR-860A UHF Synthesized Diversity Tuner. Use this connector when an optional battery and tuner are attached to the CA- 702/702P and the tuner’s power cord cannot reach the DC OUT connector on the back of the camcorder.

8POWER/MODE switch

This switch turns the power to the CA-702/702P on and off and selects the operation mode.

ON/OUT: Turns on the CA-702/702P. In this mode, the camcorder outputs video and audio signals to a portable VTR and SDI signals from the VIDEO/ SDI OUT connector (output mode).

ON/IN: Turns on the CA-702/702P. In this mode, an external video input signal (composite or SDI) can be recorded on the camcorder (input mode).

OFF: Turns off the CA-702/702P.

Notes

•When attached to a DVW-700, DVW-700WS, or DNV-5, the CA-702/702P cannot be used in input mode.

•The POWER/MODE switch controls the power to the CA-702/702P alone and cannot be used to simultaneously turn on or off the camcorder or the CA-702/702P’s DC power output.

9SDI/COMPOSITE switchSelects the video signal to be input to the VIDEO/SDI IN connector.SDI: SDI signalCOMPOSITE: Composite signal

Set the SDI/COMPOSITE switch to SDI to output an SDI signal from the VIDEO/SDI OUT connector.

Note

The SDI/COMPOSITE switch setting does not affect the video output signal to the VTR connector.

!º VIDEO/SDI OUT (video output) connector (BNC-type)

Outputs the video signal. In input mode, outputs the active-through signal fed from the VIDEO/SDI IN connector.

In output mode, outputs the picture or playback video signal from the camcorder only when the SDI/ COMPOSITE switch is set to SDI.

!¡ VIDEO/SDI IN (video input) connector (BNC- type)

Inputs the external video signal. This connector is terminated with a 75-ohm resistor inside the CA-702/ 702P. For this reason, a terminator need not be attached to the VIDEO/SDI connector.

The setting of the SDI/COMPOSITE switch can be changed according to the input signal type.

This connector cannot be used in output mode.

5(E)