Charging and installing the battery pack
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
•The CHARGE lamp will remain lit for a while even if the battery pack is removed and the power cord is unplugged after charging the battery pack. This is normal.
•If the CHARGE lamp does not light, disconnect the power cord. After about one minute, reconnect the power cord again.
•You cannot operate the camcorder using the AC power adaptor while charging the battery pack.
•When a fully charged battery pack is installed, the CHARGE lamp will light once, then go out.
Installing the battery pack
(1) Lift up the viewfinder.
(2) Insert the battery pack in the direction of the $mark on the battery pack. Slide the battery pack down until it catches on the battery release lever and clicks.
Attach the battery pack to the camcorder securely.
1 
2
Note on installing the
Use the camcorder while lifting up the viewfinder slightly.
Note on the battery pack
Do not carry the camcorder by grasping the battery pack.
8