Sony CDX-C910 manual Adjusting the volume of the bass and treble, Changing the line output, level

Adjusting the volume of the bass and treble

You can adjust the volume of the bass and treble to best fit the acoustic characteristics inside your car.

1 Press (SOURCE) to select a source (radio,

CD or MD).

2 Press (SOUND) repeatedly until “BAS” or “TRE” appears.

3 Rotate the dial to adjust the volume.

After three seconds, the display goes back to the normal playback mode.

Adjusting the turn-over frequency

You can adjust the bass and treble turn-over frequencies.

5 Press (SOUND) for two seconds. The display goes back to the normal playback mode.

Listening to each programme source in its registered surround menu

— Last Sound Memory (LSM)

You can listen to the same source always in the same surround menu even after changing the programme source or turning the unit on and off again.

Changing the line output

EN

Turn-over frequency

Frequency (Hz)

level

You can change the line output level if you distortion or other noise.

1 Press (SHIFT), then press (2) (SET UP) until “L.out” appears.

1 Press (SOURCE) to select a source (radio,

CD or MD).

2 Press (SOUND) for two seconds.

3 Press (SOUND) repeatedly until “BAS” or “TRE” appears.

Bass adjusting mode

BAS

314 Hz

Treble adjusting mode

TRE

3.1kHz

4 Rotate the dial to select the turn-over frequency.

The turn-over frequencies change as follows:

Bass:

198 Hz n250 Hz n314 Hz* n396 Hz

Treble:

2.0 kHz n3.1 kHz* n4.0 kHz n5.0 kHz

*Factory-set frequency

22

2 Press (4) (n) to select the desired setting (–10 dB or –16 dB).

3 Press (SHIFT).

Actual total number: Sony CDX-C910 (E,S,C) 3-856-715-11(2)