Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)

Mid: ±10 dB at 1 kHz (XPLOD)

High: ±10 dB at 10 kHz (XPLOD) Power requirements: 12 V DC car battery

(negative ground)

Dimensions: Approx. 178 ⋅ 50 ⋅ 177 mm (7 1/8 ⋅ 2 ⋅ 7 in) (w/h/d)

Mounting dimensions: Approx. 182 ⋅ 53 ⋅ 161 mm (7 1/4 ⋅ 2 1/8 ⋅ 6 3/8 in) (w/h/d)

Mass: Approx. 1.2 kg (2 1b 10 oz)

Supplied accessory:

Parts for installation and connections (1 set)

Optional accessories/equipment:

Card remote commander: RM-X114

Rotary commander: RM-X4S

Marine remote commander: RM-X55M

Bus cable (supplied with an RCA pin cord):

RC-61 (1 m), RC-62 (2 m)

CD changer (10 discs): CDX-757MX

CD changer (6 discs): CDX-T69

Source selector: XA-C30, XA-C40

AUX-IN selector: XA-300

Your dealer may not handle some of the above listed accessories. Please ask the dealer for detailed information.

US and foreign patents licensed from Dolby Laboratories.

MPEG Layer-3 audio coding technology and patents licensed from Fraunhofer IIS and Thomson.

Note

This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible.

Design and specifications are subject to change without notice.

•Halogenated flame retardants are not used in the certain printed wiring boards.

•Halogenated flame retardants are not used in cabinets.

•Cushions made from paper.

•VOC (Volatile Organic Compound)-free vegetable oil based ink is used for printing the carton.

16

Troubleshooting

The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.

General

No power is being supplied to the unit.

•Check the connection. If everything is in order, check the fuse.

•If the unit is turned off and the display disappears, it cannot be operated with the remote commander.

t Turn on the unit.

The power antenna does not extend.

The power antenna does not have a relay box.

No sound.

•The volume is too low.

•The ATT function is activated, or the Telephone ATT function (when the interface cable of a car telephone is connected to the ATT lead) is activated.

•The position of the fader control (FAD) is not set for a 2-speaker system.

•The CD changer is incompatible with the disc format (MP3/ATRAC CD).

t Play back with a Sony MP3 compatible CD changer, or this unit.

No beep sound.

•The beep sound is canceled (page 10).

•An optional power amplifier is connected and you are not using the built-in amplifier.

The contents of the memory have been erased.

•The RESET button has been pressed. t Store again into the memory.

•The power connecting lead or battery has been disconnected.

•The power connecting lead is not connected properly.

Stored stations and correct time are erased. The fuse has blown.

Makes noise when the position of the ignition key is switched.

The leads are not matched correctly with the car’s accessory power connector.

The display disappears from/does not appear in the display window.

•The dimmer is set “DIM-ON” (page 10).

•The display disappears if you press and hold

(OFF).

t Press and hold (OFF) again until the display appears.

•The connectors are dirty (page 14).

DSO does not function.

Depending on the type of car interior or type of music, DSO may not have a desirable effect.