Radio reception

Preset tuning is not possible.

•Store the correct frequency in the memory.

•The broadcast signal is too weak.

The stations cannot be received. The sound is hampered by noises.

•Connect a power antenna control lead (blue) or accessory power supply lead (red) to the power supply lead of a car’s antenna booster (only when your car has built-in FM/AM antenna in the rear/side glass).

•Check the connection of the car antenna.

•The auto antenna will not go up.

t Check the connection of the power antenna control lead.

•Check the frequency.

•When the DSO mode is on, the sound is sometimes hampered by noises.

t Set the DSO mode to “OFF” (page 23).

Automatic tuning is not possible.

•The local seek mode is set to “ON.” t Set the local seek mode to “OFF”

(page 21).

•The broadcast signal is too weak. t Perform manual tuning.

The “STEREO” indication flashes.

•Tune in the frequency accurately.

•The broadcast signal is too weak.

t Set the monaural reception mode to “ON” (page 21).

A program broadcast in stereo is heard in monaural.

The unit is in monaural reception mode.

tCancel monaural reception mode (page 21).

Interference occurs during FM reception.

The wide mode is selected.

tSet the IF mode to “IF AUTO” (page 21).

Error displays/Messages

Error displays

(For this unit and optional CD/MD changers)

The following indications will flash for about 5 seconds, and an alarm sound will be heard.

BLANK*1

No tracks have been recorded on an MD.*2

tPlay an MD with recorded tracks on it.

ERROR*1

•A CD is dirty or inserted upside down.*2 t Clean or insert the CD correctly.

•A CD/MD cannot play because of some problem.

t Insert another CD/MD.

FAILURE (Illuminates until any button is pressed.)

The connection of speakers/amplifiers is incorrect.

tSee the installation guide manual of this

model to check the connection. FAILURE (Illuminates for about 1 second.)

When the XM tuner is connected, storing an XM radio channel into a preset failed.

tBe sure to receive the channel that you want to store, then try it again.

HI TEMP

The ambient temperature is more than 50°C (122°F).

tWait until the temperature goes down below 50°C (122°F).

NO DISC

No disc is inserted in the CD/MD unit.

tInsert discs in the CD/MD unit.

NO MAG

The disc magazine is not inserted in the CD unit.

tInsert the magazine in the CD unit.

28