Other functionsChanging the sound settingsAdjusting the sound characteristics

You can adjust the bass, treble, balance, fader and subwoofer volume.

1Select a source, then press (SOUND) repeatedly to select the desired item.

The item changes as follows:

BASS (bass) t TREBLE (treble) t BALANCE (left-right) t

FADER (front-rear) t

SUB WOOFER (subwoofer volume)*

*“ ∞” is displayed at the lowest setting, and can be adjusted up to 20 steps.

2Rotate the volume control dial repeatedly to adjust the selected item.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

Note

Adjust within 3 seconds of selecting the item.

With the card remote commander

In step 2, to adjust the selected item, press < or ,.

Adjusting the equalizer curve— EQ7 Tune

You can adjust and store the equalizer settings for different tone ranges.

(With the card remote commander)

1Select a source, then press (MENU).

2Press M or m repeatedly until “EQ7 Tune” appears, then press (ENTER).

3Press < or , repeatedly to select the desired equalizer type, then press

(ENTER).

4Press < or , repeatedly to select the desired frequency.

The frequency changes as follows:

62Hz y 157Hz y 396Hz y 1.0kHz y 2.5kHz y 6.3kHz y 16kHz

5Press M or m repeatedly to adjust the desired volume level.

The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.

Repeat steps 4 and 5 to adjust the equalizer curve.

To restore the factory-set equalizer curve, press and hold (ENTER).

6Press (MENU) twice.

The setting is complete and the display returns to normal play/reception mode.

Adjusting menu items — MENU

You can adjust various menu settings by using the 4 arrow buttons on the card remote commander.

(With the card remote commander)

MENULIST

+

ENTER

–

DSPL/PTYSCRL

1Press (MENU).

2Press M or m repeatedly until the desired item appears.

3Press < or , to select the desired setting (example: “on” or “off”).

4Press (ENTER).

The setting is complete and the display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

Tip

You can easily switch among categories by pressing and holding M or m.

The following items can be set (follow the page reference for details):

“z” indicates the default settings.

Setup

Clock Adjust (Clock Adjust) (page 4)

CT (Clock Time)

To set “on” or “off” (z) (page 9, 10).

continue to next page t

11