Tuner section

FM

Tuning range: 87.5 – 107.9 MHz

Antenna (aerial) terminal:

External antenna (aerial) connector Intermediate frequency: 10.7 MHz/450 kHz Usable sensitivity: 9 dBf

Selectivity: 75 dB at 400 kHz

Signal-to-noise ratio: 67 dB (stereo), 69 dB (mono)

Harmonic distortion at 1 kHz: 0.5 % (stereo),

0.3% (mono) Separation: 35 dB at 1 kHz Frequency response: 30 – 15,000 Hz

AM

Tuning range: 530 – 1,710 kHz

Antenna (aerial) terminal:

External antenna (aerial) connector Intermediate frequency: 10.7 MHz/450 kHz Sensitivity: 30 µV

Power amplifier section

Outputs: Speaker outputs (sure seal connectors)

Speaker impedance: 4 – 8 ohms

Maximum power output: 52 W ⋅ 4 (at 4 ohms)

General

Output:

Audio outputs terminal

Front (CDX-GT320/GT32W only) Sub/Rear switchable

Power antenna (aerial) relay control terminal Power amplifier control terminal

Inputs:

BUS control input terminal (CDX-GT320/GT32W only)

BUS audio input terminal (CDX-GT320/GT32W only)

Antenna (aerial) input terminal AUX input jack (stereo mini jack)

Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)

Mid: ±10 dB at 1 kHz (XPLOD)

High: ±10 dB at 10 kHz (XPLOD)

Loudness:

+4 dB at 100 Hz

+2 dB at 10 kHz

Power requirements: 12 V DC car battery (negative ground (earth))

Dimensions: Approx. 178 ⋅ 50 ⋅ 179 mm (7 1/8 ⋅ 2 ⋅ 7 1/8 in) (w/h/d)

Mounting dimensions: Approx. 182 ⋅ 53 ⋅ 162 mm (7 1/4 ⋅ 2 1/8 ⋅ 6 1/2 in) (w/h/d)

Mass: Approx. 1.2 kg (2 lb 11 oz)

Supplied accessories:

Card remote commander: RM-X151 (CDX-GT320/GT32W only)

Parts for installation and connections (1 set)

Optional accessories/equipment: for CDX-GT220/GT22W

Card remote commander: RM-X114 for CDX-GT320/GT32W

BUS cable (supplied with an RCA pin cord): RC-61 (1 m), RC-62 (2 m)

CD changer (10 discs): CDX-757MX

CD changer (6 discs): CDX-T69

Source selector: XA-C40

AUX-IN selector: XA-300

Interface adaptor for iPod: XA-120IP

HD Radio™ tuner: XT-100HD

Your dealer may not handle some of the above listed accessories. Please ask the dealer for detailed information.

MPEG Layer-3 audio coding technology and patents licensed from Fraunhofer IIS and Thomson.

Design and specifications are subject to change without notice.

•Halogenated flame retardants are not used in the certain printed wiring boards.

•Halogenated flame retardants are not used in cabinets.

•Packaging cushions are made from paper.

Troubleshooting

The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.

General

No power is being supplied to the unit.

•Check the connection. If everything is in order, check the fuse.

•If the unit is turned off and the display disappears, it cannot be operated with the remote commander.*2 t Turn on the unit.

The power antenna (aerial) does not extend. The power antenna (aerial) does not have a relay box.

No sound.

•The volume is too low.

•The ATT function is activated.

•The position of the fader control “FAD” is not set for a 2-speaker system.

•The CD changer is incompatible with the disc format (MP3/WMA).*1

t Play back with a Sony MP3 compatible CD changer, or this unit.

No beep sound.

•The beep sound is canceled (page 9).

•An optional power amplifier is connected and you are not using the built-in amplifier.

The contents of the memory have been erased.

•The RESET button has been pressed. t Store again into the memory.

•The power supply lead or battery has been disconnected.

•The power supply lead is not connected properly.

continue to next page t 15