Fuse replacement |
| |
When replacing the fuse, be |
| |
sure to use one matching the |
| |
amperage rating stated on the |
| |
original fuse. If the fuse blows, |
| |
check the power connection and |
| |
replace the fuse. If the fuse |
| |
blows again after replacement, |
| |
there may be an internal |
| |
malfunction. In such a case, | Fuse (10A) | |
consult your nearest Sony | ||
| ||
dealer. |
|
Cleaning the connectors
The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 4) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged.
Main unit | Back of the front |
| panel |
Notes
•For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.
•Never touch the connectors directly with your fingers or with any metal device.
Removing the unit
1Remove the protection collar.
1Detach the front panel (page 4).
2Engage the release keys together with the protection collar.
Orient the release keys as shown.
3Pull out the release keys to remove the protection collar.
2Remove the unit.
1Insert both release keys simultaneously until they click.
Hook facing inwards.
2Pull the release keys to unseat the unit.
3Slide the unit out of the mounting.
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5 % total harmonic distortion.
CEA2006 Standard
Power Output: 17 Watts RMS ⋅ 4 at 4 Ohms < 1% THD+N
SN Ratio: 82 dBA
(reference: 1 Watt into 4 Ohms)
CD Player section
Signal-to-noise ratio: 120 dB
Frequency response: 10 – 20,000 Hz
Wow and flutter: Below measurable limit
14