Other functions
Changing the sound settings
Adjusting the sound characteristics — BAL/FAD/SUBYou can adjust the balance, fader, and subwoofer volume.
1Press the select button repeatedly until “BAL,” “FAD” or “SUB” appears.The item changes as follows:
LOW*1 t MID*1 t HI*1 tBAL
*1 When EQ3 is activated (page 9).
*2 When the audio output is set to “SUB” (page 9). “ATT” is displayed at the lowest setting, and can be adjusted up to 20 steps.
*3 When AUX source is activated (page 10).
2Rotate the volume control dial to adjust the selected item.After 3 seconds, the setting is complete and the display returns to normal play/reception mode.
With the card remote commander
In step 2, to adjust the selected item, press <, M, , or m.
Customizing the equalizer curve— EQ3“CUSTOM” of EQ3 allows you to make your own equalizer settings.
1Select a source, then press (EQ3) repeatedly to select “CUSTOM.”2Press the select button repeatedly until “LOW,” “MID” or “HI” appears.3Rotate the volume control dial to adjust the selected item.The volume level is adjustable in 1 dB steps, from
Repeat steps 2 and 3 to adjust the equalizer curve.
To restore the
After 3 seconds, the setting is complete and the display returns to normal play/reception mode.
Tip
Other equalizer types are also adjustable.
With the card remote commander
In step 3, to adjust the selected item, press <, M, , or m.
Adjusting setup items — SET
1Press and hold the select button.
The setup display appears.
2Press the select button repeatedly until the desired item appears.3Rotate the volume control dial to select the setting (example “ON” or “OFF”).4Press and hold the select button.The setup is complete and the display returns to normal play/reception mode.
Note
Displayed items will differ, depending on the source and setting.
With the card remote commander
In step 3, to select the setting, press < or ,.
The following items can be set (follow the page reference for details):
“z” indicates the default settings.
To set
To turn the AUX source display
To switch the audio output.
–
–
DIM (Dimmer)
To change the brightness of the display.
–
–
–
To adjust the contrast of the display.
The contrast level is adjustable in 7 steps.
M.DSPL*2 (Motion Display)
To select the Motion Display mode.
–
–
–