Getting Started

Resetting the unit

Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit.

Detach the front panel and press the RESET button with a pointed object, such as a ball-point pen.

RESET button

Note

Pressing the RESET button will erase the clock setting and some stored contents.

Setting the clock

The clock uses a 12-hour digital indication.

1Press and hold the select button.

The setup display appears.

2Press the select button repeatedly until “Clock Adjust” appears.3Press (DSPL).

The hour indication is selected.

4Rotate the volume control dial to set the hour and minute.

To move the digital indication, press (DSPL).

5Press the select button.

The setup is complete and the clock starts.

With the card remote commander

In step 4, to set the hour and minute, press M or m.

Detaching the front panel

You can detach the front panel of this unit to prevent theft.

Caution alarm

If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used.

1Press (OFF).

The unit is turned off.

2Press (OPEN).

The front panel is flipped down.

3Slide the front panel to the right, then gently pull out the left end of the front panel.

1

2

Notes

•Do not drop or put excessive pressure on the front panel and display window.

•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.

4