Under normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.)

When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion.

+ side up

2 c 1

Notes on the lithium battery

•Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

•Wipe the battery with a dry cloth to assure a good contact.

•Be sure to observe the correct polarity when installing the battery.

•Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.

WARNING

Battery may explode if mistreated.

Do not recharge, disassemble, or dispose of in fire.

Notes

•For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.

•Never touch the connectors directly with your fingers or with any metal device.

Removing the unit

1Remove the protection collar.

1Detach the front panel (page 5).

2Engage the release keys together with the protection collar.

Orient the release keys as shown.

3Pull out the release keys to remove the protection collar.

Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case,

2Remove the unit.

1Insert both release keys simultaneously until they click.

Hook facing inwards.

consult your nearest Sony dealer.

Fuse (10A)

Cleaning the connectors

The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 5) and clean the connectors with a cotton swab. Do not apply too much force. Otherwise, the connectors may be damaged.

2Pull the release keys to unseat the unit.

3Slide the unit out of the mounting.

Main unit

Back of the front

17

 

panel