Sony CDX-M8805X specifications Audio Power Specifications, CD Player Section, Tuner Section

2004 SONY MOBILE

PRODUCT GUIDE

CDX-M8805X

FM/AM Compact Disc Player

Audio Power Specifications

• Fixed Active Black Panel design	• 8fs, 1-bit D/A converter
• FL ABP Display	• 45 degree install
• MP3 playback	• CD-R/RW playback
• BBE MP	• SSIR-EXA tuner, Station Memo
• 4-Volt F/R/Sub Preamp output	• 18FM + 12AM memory presets
with HPF/LPF	• Blue key illumination
• CD/MD control, CD Text	• Supplied wireless card remote
• XM Ready	(RM-X143A)
• DSO, EQ7	• Optional wireless rotary remote
• 52W x 4 high power	(RM-X6S)
• Aux Lite auxiliary input	• Optional wired rotary remote
• Drive-S	(RM-X4S)

POWER OUTPUT AND TOTAL HARMONIC DISTORTION

23.2watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion

CD Player Section

Signal-to-noise ratio	120 dB
Frequency Response	10 - 20,000 Hz
Stereo Separation	85 dB
Total Harmonic Distortion	0.01%
Tuner Section
FM		AM
Tuning Range	87.5 - 107.9 MHz	Tuning Range	530 - 1,710 kHz
Antenna Terminal	External antenna connector	Antenna Terminal	External antenna connector
Intermediate Frequency	10.7 MHz/450 kHz	Intermediate Frequency	10.7 MHz/450 kHz
Usable sensitivity	9 dBf	Sensitivity	30 µV
Selectivity	75 dB at 400 kHz
Signal-tp-noise ratio	67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz	0.5% (stereo), 0.3% (mono)
Separation	35 dB at 1 kHz
Frequency response	30 - 15,000 Hz
Power Amplifier Section
Outputs	Speaker outputs (sure seal connectors)
Speaker impedance	4 - 8 ohms
Maximum power output	52 W x 4 (at 4 ohms)
General			Harness Plug Configuration

Preamp Output Level	4 Volts
Preamp Impedance	220 ohms
Outputs	Audio outputs (front, rear)	Subwoofer output (mono)
	Power antenna relay control terminal
	Power amplifier control terminal
Inputs	Telephone ATT control terminal
	BUS control input terminal or AUX IN terminal
	BUS audio input terminal
	Remote controller input terminal
	Antenna input terminal
Tone controls	Bass: ±10 dB at 62 Hz
	Treble: ±10 dB at 16 kHz
Loudness	+8 dB at 100 Hz, +2 dB at 10 kHz
Power requirements	12 V DC car battery (negative ground)
Dimensions	Approx. 178 x 50 x 184 mm
	(7 1/16 x 2 x 7 1/4 in.) (w/h/d)
Mounting dimensions	Approx. 182 x 53 x 162 mm
	(7 1/4 x 2 1/8 x 6 3/8 in.) (w/h/d)
Mass	Approx. 1.7 kg (3 lb. 12 oz.)
Supplied accessories	Card remote commander (RM-X143A)
	Parts for installation and connections
Optional accessories	Rotary remote commander (RM-X4S)
	Rotary remote commander (RM-X6S)

	1	2	3	4	5	6	7	8
	9	10	11	12	13	14	15	16
	Plug shown with wires facing viewer
Pin Number	Wire Color				Description
1	White				Left front +
2	Green				Left rear +
3	Purple				Right rear +
4	Gray				Right front +
5	Blue/white				AMP Remote
6	Blue				ANT Remote
7	Red				Accessory
8	Black				Ground
9	White/black				Left front -
10	Green/black				Left rear -
11	Purple/black				Right rear -
12	Bray/black				Right front -
13	Sky blue				ATT
14
15	Orange/white				Illumination
16	Yellow				Battery

Note

This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible.

Design and Specifications subject to change without notice.